Smoant Charon Baby Plus Pod Kit

Discussion in 'General Vendor Discussion' started by Gina, Nov 22, 2021.

  1. Gina

    Gina Guru

    May 31, 2016
    Likes Received:

    Smoant Charon Baby Plus Pod System Vape Kit, This Charon Baby+ pod system features magnetic replaceable 3D panels, puff-activated firing, built-in 1000mAh battery, all vape styles, adjustable airflow control, fast charging, 3.5ml pod cartridge, new mesh coils that last longer, and multiple protections. the replaceable panels that are held in place by way of strong magnets. This means you can swap them out at any time for a brand new appearance that is sure to turn heads thanks to a wide range of graffiti-like prints. All the Charon Baby Plus panels use brand new UV 3D prints with 2-layered protective UV films to ensure longevity, fingerprint resistance, and bright colors.

    There is an AI smart ant-chip that auto-adjusts wattage according to which coil is installed inside the pod cartridge.
    A white light means that the battery charge percentage is above 70 percent, blue means 20 to 70 percent, while a red light means you should probably plug the device into any USB outlet with the included cable.

    This Charon Baby Plus Pod Kit has three compatible coils, but you may also install Santi Coils if that is what you prefer. With purchase, you will get two 0.6 S-2 coils for restricted direct-to-lung vaping at 18 to 25 watts. And, there are two other coils you may buy separately: the S-1 DL coil has a 0.4ohm resistance and works from 30 to 35 watts, while the optional S-3 MTL coil has a 1.2ohm resistance and fires from 8 to 12 watts. All of these heads are built with mesh heating elements that heat up fast for instant, flavorful vapor production.
    As you may have seen in the previous paragraph, the coils of smoant charon baby+ allow DL, RDL, or MTL vaping, but airflow is also adjustable. Moreover, the Charon Baby Plusutilizes a unique U-shaped internal air channel and a dual independent airflow system. In this way, you may have a versatile vape experience. To change the airflow setting, you can slide a convenient button into your preferred air intake position.

    Power output: 1~35W
    Voltage range: 3.2~4.2V
    Charging: 5V / 1A
    Charging port: Type-C
    Cartridge capacity: 3.5ml
    Battery: 1000mAh
    Output Mode: Auto-adjust wattage by resistance
    Resistance Range: 0.3~3.0ohm
    Material: Zinc alloy + PCTG
    Compatible with Santi S-coils (S-2 Mesh 0.6ohm Coil)
    U type airflow control system and dual independent airflow system
    Auto-adjust wattage & auto draw
    Side air inlet, no leaking
    Replaceable magnetic 3D panel
    2-layers protective UV films technology
    1000mAh built-in battery
    Supports DL, RDL, MTL vaping
    New wire material with mesh structure
    3.5ml pod with strong magnet
    1A type-c fast charging
    AI smart Ant-chip
    Multiple protection: Low Voltage / No-load / Overtime / Short-circuit / Overcharge Protection

    More details for the Charon Baby+ Pod Kit, please check >>
  2. Gina

    Gina Guru

    May 31, 2016
    Likes Received:

Share This Page