5AVape Rose V2S RTA Clone

Discussion in 'General Vendor Discussion' started by Gina, Jul 2, 2021.

  1. Gina

    Gina Guru

    Joined:
    May 31, 2016
    Messages:
    5,106
    Likes Received:
    0
    Today brings a new clone RTA from 5AVAPE. The ROSE V2S Clone.

    [​IMG]

    The 5AVape Rose V2-S RTA Clone rebuildable tank atomizer is made of 316 stainless steel. You can rest your inverted Rose while re-coiling without fear of spilling your e-juice.

    Features:
    Single coil or dual coil configurations - Single coil with 2 wicks or 2 coils with a wick each;
    Sliding airflow control ring;
    Juice flow control - By turning the drip tip;
    You can adjust the flow of juice onto the coil;
    Ceramic coil cup - You can choose not using the coil cup if you prefer;
    Re-coiling without emptying tank - Simply invert and unscrew the coil head assembly for re-coiling;
    No resistance wire not needed - Careful attention has been made to the ease of setting up a coil in the RTA;
    Inverted or regular e-juice filling - Either remove the coil head or the top cap to fill with your favorite e-juice;
    510 connection with adjustable brass center pin;
    Height excludes the mouthpiece and connector: 56.5mm;
    Laser engravings;
    Comes with a stand made from stainless steel so you can rest your inverted Rose while re-coiling without fear of spilling your e-juice;
    If you invert the stand;
    It will allow you to store your Rose by screwing it into the 510 thread on the stand

    [​IMG]

    More on https://www.3fvape.com/50594-5avape-rose-v2s.html
     

Share This Page